Ford F-150 Lightning Nitrous Install - Is the Juice Worth the Squeeze?
|
With the cold-air intake out of the way, it was time for Shaun to drill and tap the hole for the nozzle. First and foremost, stuff a rag down the inlet tube to the blower, then place tape (sticky side up) around the area where you plan to drill the hole, both inside and outside of the inlet tube. You definitely don't want a small piece of aluminum to make its way into the blower case. With only around 10-thousandths of an inch clearance between the blower rotors, even a small sliver of aluminum will stop the blower from spinning. View Related Article
|
|