Packing More ProCharger Performance Part 2 - ProCharger D-1SC Supercharger
|
The best way to cut braided line is with a cut-off wheel or a fresh hacksaw blade and a bench vise. Be sure to use masking tape at the cut to keep the braided line from fraying. Use some penetrating oil to lube up the line and the fittings, and twist the nut on to the fuel line until the base is fully seated. Then install the male end of the AN fitting. Aeromotive recommends a gap of no more than 0.030 inch between the two fittings, but don't overtighten them as they are aluminum. View Related Article
|
|