In this photo series, you can see how Lacko mounted the arming switch, purge button, and bottle heater switch in the dash bezel. He started by removing the bezel from the dash, leaving the area open for Spector to run the wiring for the purge, nitrous power lead, and bottle heater under the dash and into position. With the bezel on the bench, Lacko sourced some rocker switches and the push-button switch (for the purge) from a local auto parts store, marked off where they needed to be installed, and carefully drilled out the needed holes in the bezel. We wanted to go for the sleeper/factory look, so we used these slick switches instead of those supplied in the kit. Once the switches were in, the wires were hooked up and the bezel reinstalled on the dash of the truck. Unless you know what to look for, you can hardly tell what the switches are for.