search musclemustangfastfords.com

Measure

 
 
Measure
Measure
With the bottle shroud in the bottle brackets, Shaun Lacko of JDM carefully situated the bottle in the bed, moving it around until he found the mounting point he liked best. Once he had the bottle in the correct spot, he took a Sharpie marker, marked where he needed to drill the holes for the bottle brackets, and then proceeded to drill in the bed. To access the bed and make drilling easier, remove the tailgate. Drill a small pilot hole first before drilling the hole to the correct size. In addition to drilling the holes for brackets, Lacko also drilled holes for the nitrous line and bottle heater wires to go through. View Related Article
Lightning Back Cab Dashboard Drilling Pick A Place Measure Place It
Nitrous Kit Pressure Gauge Place It In Bottle It Inspect The Lines Template Connect
Arm Switch Install Throttle Switch Remove Cold Airintake Replace Stero Frame Wiring Switch Drill A Hole
Place For Nozzle Position Hook Them Guages Ready Bottle Cooler Drain Fuel
Refill Tank Cool The Engine Air Fuel Monitored Dyno Research Final Result Done Rolling Out
Muscle Mustangs & Fast Fords
Muscle Mustang & Fast Fords